|
Shown are 2, 3, 7, and 12 motor Cluster Cables. These are also called model rocket clip whips. These cables allow easier, more reliable, and a more professional way to attach you cluster
model rocket to your launch controller. Attach the single pair end to your launch controller and the other ends are attached to your motors - up to 12!
Each set is quality made with only the best components. The clips are copper with flat surfaces for more surface area to grab on to.
Easy to clean with sandpaper or a fine wire brush. Heat shrink tubing applied to joints for more strength and isolation.
Soldered joints. Each set checked for shorts and continuity.
Based on designs from Daniel Barrett of DMB Rocketry
These Motor Cluster Cables are made with Lead Free Soldier but may contain some impurities which may contain lead in small quantities
WARNING: The LEAD FREE SOLDER used in making the Motor Cluster Cables CONTAINS TRACES OF LEAD which is a chemical
known to the state of California to cause cancer and birth defects or other reproductive harm. Federal and State/ Provincial laws
prohibit the use of lead solder in making solder joints in any private or public potable (drinking) water supply system.
After handling solder, wash hands with soap and water before eating or drinking.
Each Cluster Cable has a Lot Number. This Lot Number must be kept with the Motor Cluster Cable at all times for reference and tracking purposes.
THE LOT NUMBER IS NOT TO BE DISCARDED
DATA SHEETS:
The following are data sheets for Lot Numbers listed
LOT NUMBER N701723: Certificate of Analysis N701723
|
